Go Around Page – Description #
This is an example of the Go Around Page not active (preflight). The title line displays white when phase is not active and green when the phase is active.
When the go-around phase is active, the climb/cruise phase can be activated by manually changing the destination on the flight plan page and inserting a new cruise altitude on the PROG page. Until the new altitude is entered, managed speed remains at green dot (clean speed).
It can also be activated by enabling the alternate, which automatically changes the destination and inserts a new cruise altitude. If the airplane is below the new cruise altitude, the climb phase activates. Otherwise, the cruise phase activates.
PREV PHASE – Provides access to Approach page – LS 6L.
F, S, Clean Speeds #
Displays flap and slat retraction speeds, and green dot speed. Cannot be modified by the pilots.
THR Red #
Altitude at which thrust should be reduced from TO/GA thrust to maximum climb thrust.
Defaults to 800 feet above destination runway elevation. Can be modified by the pilots but is always lower than or equal to ACC altitude (minimum of 400 feet above destination runway elevation).
ACC #
Acceleration Altitude –
Altitude at which target speed changes to green dot speed (managed speed). Defaults to 800 feet above destination runway elevation.
Can be modified by the pilots but is always equal to or higher than THR RED altitude.
Engine Out ACC #
Displays engine out acceleration altitude. Defaults to 800 feet above destination runway elevation.
For display only; however, can be modified by the pilots.
